Removing unfired load

[AJ]

The water deal is BS. Just remove your breechplug and push the load through the rest of the barrel. You can do it this way or you can use a ball puller and pull it back through the barrel and out the muzzle. It is a lot harder to pull one back out than it is to push one the rest of the way through. That is unless you use a sidelock. Then thats the only method. I typically just push the bullet/powder charge through the breech.

[too_pointer]

I do the same as AJ, very easy and quick. http://www.realtree.com/forums/images/graemlins/smirk.gif
too_pointer

[wtnhunt]

Yep, I push mine out after removing the breech plug. Pretty simple and quick. Have never used water to saturate the powder either. Think that would be kinda messy.

[robk]

if you don't want to shoot then pull the breech plug and catch your powder whether loose or pellets and push your bullet out. then clean it that way. i like to shoot it as i don't like to really handle the pellets and the oil form my hands on it and i use a pipe cleaner to load it in my barrel and i just shoot it out and clean it i shoot an encore so it;s not really hard to clean either
rob k

[RangerClay]

Thompson Center make a silent discharger that uses a CO2 cartridge. I have one and it works great! http://www.realtree.com/forums/images/graemlins/wink.gif

Ranger

[Swamphunter]

[ QUOTE ]
Thompson Center make a silent discharger that uses a CO2 cartridge. I have one and it works great!


[/ QUOTE ]

Me too... just chews through a lot of Co2 cartridges... http://www.realtree.com/forums/images/graemlins/grin.gif